Writen Instructions On How To Make A Finger Trap

Writen Instructions On How To Make A Finger Trap. Make two l shaped pieces by gluing two strips together at a 90° angle. A square piece of paper, workpiece size 4,5cm * 4,5cm (if you don't want a finger trap you can also get any square piece size paper) 2.

Funny Origami FINGER TRAP. How to make a paper antistress toys. DIY fidget toy. Turbo Fun Crafts from turbofuncrafts.com

Recruit the nurse to help continue these reassurances while you are away from the bedside. The traction device may be suspended from an iv pole or traction system. Fold a piece of construction paper into 3rds lengthwise.

Start Folding By Placing The White Side Of The Paper Up Towards You.

After the 4 fingers are prepared, take the end and wrap it around the. Glue the 2 outside folds down. Once fingers are secure in traps, place the loop of the finger trap in the appropriate clip on isi's digi grip or other traction device.

Place Patient's Fingers In Finger Traps.

To show this video you can eas. Fold the rectangle in half, bringing the 2 short edges together. Fold the long gauze in half.

Glue The Top Flap Down To Hold The Folds In Place.

Weave the strips together as shown below, tightening. Fold each flap down so the edges line up with the center fold. The traction device may be suspended from an iv pole or traction system.

The Double Traps Make It Easy To Quickly Fit And Secure A Patient For Traction Cases.

Once fingers are secure in traps, place the loop of the finger trap in the appropriate clip on isi's digi grip or other traction device. Make two l shaped pieces by gluing two strips together at a 90° angle. Place patient's fingers in finger traps.

The Double Nylon Finger Trap Provides A Firm Grip, Yet Are Gentle On The Patient's.

Place the patient’s index and middle fingers into the loops and hang the long tail from a tall iv pole Repeat the process for the middle and ring fingers. I found a similar version on the internet, but i modified the.