How To Make An Origami Model Dragon. Tape the popsicle sticks near the head and the tail, as shown in the photo. Fold the other paper plate in half so that the outsides are concave.
Origami Dragon by orimin on DeviantArt from www.deviantart.com
Take a small sheet of origami paper and then fold the paper down and make sure the top edge of the paper aligns with the bottom edge of the paper and make a proper crease by putting finger pressure on it. Open one of the triangle flaps. You may like to cut out a small slot on one side to make it easier to slot your hand in when using the puppet.
Origami Dragon, Origami Instructions I Love This Model Because It’s Relatively Simple To Fold And Great For.
Fold this triangle in half again. Youll be able to fold many origami models in no time. This model starts out from a bird base so if you have ever folded an origami crane the first few steps will be familiar to you.
There Are Lots Of Origami Models That Are Easy And Fun To Fold.
This model starts out from a bird base so if you have ever folded an origami crane the first few. 5 fold the flat half of the paper backwards, then crease it. 4 fold the paper in half widthwise.
Unfold 27 Dragon Horn/Ears Turn That End Inside Out And Fold Back Along The Top Edge Of What Is To Become The Head.
How to make origami dragon. Fold the other paper plate in half so that the outsides are concave. Stick the head and the tail to the two ends of the red strip.
Open One Of The Triangle Flaps.
Cut one of the paper plates in half. Begin with a square piece of paper. It’s harder to design easy models than it is to design complex ones.
How Do You Make A Dragon Stick?
Fold either side up, making an inside reverse fold. Fold the front flaps at the bottom backwardsfold those in. A 10 square will fold into a 6 dragon, but i recommend using a larger sheet if available.
