Unfold it so that you have a crease marking the center of the paper. Shake off any loose glitter and set aside until dry.
Now just pressing on the flaps pull down on the flaps and pull up on the bottom.
How to make a paper poper. Wrap the tissue paper around the toilet paper. Robs World In this video for my design I explain how to make an easy paper popper sometimes called a flapper or banger. Place the two pieces of the toilet paper roll at the bottom center of the tissue paper with half an inch of space between the rolls.
Tie the tail of the balloon in a knot snip the opposite side off as shown. Lastly fold it outwards so it creates a triangle. When you are done you can make very loud POPs with a flick of your wrist.
Before the glue begins to dry sprinkle glitter generously over the toilet paper tube until you reach the desired effect. How to Make a Paper Popper Author. If you are recycling rinse your cup and dry.
Fold each of the four corners into triangles. Cracker snaps these are the things that make the loud bang when you pull the party popper apart scissors. Like this Video.
It should create a loud pop. 2 Then make your party popper popper get tip off a balloon. Fold the paper in half lengthways.
You can also fasten paper. Trim scrapbook paper to size and using tape or glue wrap securely around tube. As it gets broken in it usually gets louder.
Turn it sideways to the landscape view. Cut a strip of your decorative paper long enough to cover the outside of roll. Here is how you make a Paper Popper.
All of these supplies come in the craft kit. Then let go of the bottom and make sure you are holding just the flaps. Then cut the bottom of your cup out.
Wrap the balloon around the toilet paper roll and staple to secure. Then fold the paper inside the tube and use tape to fasten it there. The harder you flick the louder it will be.
Apply a thin layer of liquid glue around the tube with a paintbrush. Cut the toilet paper roll in half or if you are using a paper towel roll cut into equal size pieces approximately 2-3. Fold the paper in half the long way.
Step 1 Cover the toilet paper roll with paper. If you have some extra paper hanging off one end of your roll use your scissors to cut it. Heres what you need for these awesome party poppers.
Use a stapler to fasten the paper to the roll at the ends so it doesnt come unrolledStep 2 Cut free any excess paper. Do this with scissors or a knife but take care with a knife and do it for the kids. How To Make an Easy Paper Popper – Origami – YouTube.
Now take your popper and make the two holes face you like in pictures Then place your thumbs on the two flaps and grab the bottom. Hold it as shown in the second photo and whip your arm in a downwards motion. Start with a regular sheet of printer paper.
One sheet of paper. Steps to make a paper popper. Begin your crease in the center of the fold to help keep your edges straight.
Find out how to make a paper popper.