Go to the Paper tab and select the Paper size. There is an 8 page minimum and a 92 page maximum with saddle stitching.
I ripped out the pages from my book first.
How to fold paper cones out of book pages. And heres the next. Heres the first fold you should make dividing the page in half. Glue cones onto the back of the wreath form.
I began on the section that would be the back of my wreath. Make a book page garland with or without a bouquet That took negative 3 minutes to make. I recommend using something thicker than regular paper.
Roll a single book page into a cone. Folding your papers in half is pretty straightforward. If you are not a perfectionist just roll the paper up into a pleasing looking pointy cone.
Staple the end approximately 34 inch 2 cm from the tip. With the point towards you roll the short side of the page underneath the long side if you want the points lined up. Fold one side back and flip it over and fold the other side back so when it is opened it looks like a W.
Unfold the sheet and fold it in half along the other dimension. Take a pencil and with your book closed make a mark across all the pages about halfway between the spine of the book and the edge of the book. I just cut more leaf shapes out of a thicker book.
I started to glue the paper cones to the back of the wreath form. If you have a long document you might want to split it into multiple booklets which you can then bind into one book. Select and increase the value of Gutter to reserve space on the inside fold for binding.
Since the pages are folded in half that means that your booklet page count must be in increments of four. Under Sheets per booklet choose how many pages to print per booklet. Cut along the red dotted lines that are indicated in the diagram.
Start from the top right section fold it to the left and make a concertina like an M shape with the sections until you reach the left side. You have now created creases along the edges of each of the panels that will become the pages of the book. Unfold the paper back out.
After your pages are printed out and in order I cant stress this enough youll want to add a cover. Then I rolled some paper and hot glued the mess together keeping in mind that flowers usually have something coming out of the middle and the leaves or petals all around. I use cardstock personally I like that its stiff but still easy to fold.
These will be your folding guides. 3 Fold the Pages in Half. Fold the right edge and the left edge to the central crease and unfold.
Then I rolled the pages into cones and used hot glue to hold them each into a cone shape. Do the same on the bottom of the page. Saddle stitching is when single sheets of paper printed on both sides and collated in page number order are folded in half and then stitched.
Unfold it again and then fold the page into quarters. Make cones out of book pages.